The Checkers Alley Bump Speed Bump, model was developed specifically to address speeding and cut-through traffic in city alleyways, slowing cars to approximately 1-5 MPH. Constructed from 100% recycled tires, the flexible design conforms to the contour of virtually any road surface. Pre-drilled holes make it simple to install on both asphalt and concrete. Applicable hardware is available for concrete or asphalt installations. Designed to withstand extreme weather and stress, moisture, oil, temperature variations and ultraviolet light, the Alley Bump will not chip, crack, fade, crumble, rot or deteriorate. A channeled bottom helps facilitate drainage as well as cover cabling or piping. This speed bump with its 12 in W x 48 in L x 3 in H dimensions, has a maximum weight capacity of 40000 lbs. Its brittleness factors in at -40F without change. Weathering up to 70 hours and at 150 F with no minimal change in hardness, compressive strength, tensile strength and elongation retainment. These speed bumps offer a warranty of three years on the main speed bump, with 1 year on the reflective tape (under normal use). End caps are used to protect the ends of the speed bump or speed bumps row from excessive wear and tear and are required by the warranty policy of the rubber speed bumps. End caps sold separately.
- Reduces speed to 1-5 MPH
- Molded highway reflective tape and "Cats Eye" Reflectors makes curb highly visible at night
- Modular design covers the width of any roadway and conforms to uneven surfaces and gravel
- Resistant to damage from ultraviolet light, precipitation, oil/gas runoff, road salt and extreme weather swings
- Made with corrosion resistant recycled rubber for long lasting durability
- End caps available for added protection
